Ask your bathroom related questions here
- Posts: 3
- Joined: Sat Sep 30, 2017 5:51 pm
Gutted a bathroom and scraped the floor to the concrete slab. Just wondering how much of the glue I have to get off to make sure the the tile sticks to the concrete. The floor isn’t completely clean of the glue, I’m guessing about 75 percent with quarter size patches of glue throughout. Should I keep scraping or you think I’m good to try and put the tile down.
- Posts: 13839
- Joined: Fri Nov 25, 2011 11:58 pm
- Location: Canada
I will assume you are going to use thinnest to install the tiles. I personally would give this another go with scraping. Try a razor scraper and see if you can get more off.
If you've found our videos or website information helpful, please considering making a donation using PayPal
or pledging us on Patreon
- Posts: 6653
- Joined: Tue Aug 16, 2016 5:23 pm
- Location: California, USA
agreed, if using thinset to set the tile, scrape it clean with a razor scraper
If the women don't find you handsome, they should at least find you handy.
- Posts: 8
- Joined: Mon Jan 16, 2017 7:14 pm
Scraping is best. Do not be tempted to use a solvent as that will drive the adhesive further into the slab
- Posts: 3765
- Joined: Sat Jan 03, 2015 4:03 pm
- Location: St. Paul, MN
You could also try sanding it off, maybe.
- Posts: 6
- Joined: Tue Oct 15, 2019 1:01 am
You can remove the tile adhesive residue through tile adhesive remover. let it there for a while and then scrape away the remaining glue.