Page 1 of 1

Framing

Posted: Sat Feb 16, 2019 8:54 am
by keghorn
Hi Shannon installed rigid foam against concrete basement wall would you recommend the framing be tight against the foam or can i leave a small gap to run electrical wiring.thanks very much

Re: Framing

Posted: Sat Feb 16, 2019 4:53 pm
by Shannon
I would leave as much as a 1" gap so you have some play if the concrete is not straight or plumb but don't run your wiring in there. It needs to be drilled through the studs or stapled on the back of them.