Laundry Room Framing & Plumbing

Ask your questions pertaining to the interior that don't fit in the above categories
Post Reply
TomK
Posts: 35
Joined: Fri Dec 22, 2017 3:09 pm

Laundry Room Framing & Plumbing

Post by TomK » Wed Nov 27, 2019 3:12 pm

Hi Shannon,

Reviewed some of the forum posts done earlier so I got a general idea of what I could do. However, wanted to bounce some ideas off off the folks here and ask a couple of questions:

1) If I have piping close to a wall such as this, how can I go about framing it properly?
2) Planning to move the drainpipe, sink and vent away from the wall by about 2" inch to make room for the XPS and 2x4's then enclose it in a new vanity. Can I move the vent pipe to the corner?
3) If I have XPS then 2x4's, can I enclose water and drain pipes in the 2x4's? Since this will be on the cold side of the insulation, what's the danger of freezing?

Images:
https://drive.google.com/open?id=1WhTTD ... b68nIG3Nl1
https://drive.google.com/open?id=1OY6r0 ... YS6Yum69Br
https://drive.google.com/open?id=1FfGyn ... wVzuYKrJT4

Thx,

User avatar
Shannon
Posts: 13531
Joined: Fri Nov 25, 2011 11:58 pm
Location: Canada
Contact:

Re: Laundry Room Framing & Plumbing

Post by Shannon » Wed Nov 27, 2019 6:49 pm

I think you would be fine to move the vent towards the corner. I would not recommend leaving drains or water supply lines in an exterior insulated wall.
If you've found our videos or website information helpful, please considering making a donation using PayPal or pledging us on Patreon

Post Reply