Fernco to Caste iron bell?

Discuss plumbing related issues here - pex, drains, etc.
Post Reply
Jamie
Posts: 1
Joined: Sat Jul 19, 2014 7:24 am

Fernco to Caste iron bell?

Post by Jamie » Sat Jul 19, 2014 7:32 am

I'm adding a bathroom and I am tapping into a four inch caste iron waste pipe. I'm in a spot where there is very little room and the best place to cut the iron pipe is at a hub. Do rubber fittings fit hubs, or do I need to find another spot? The section actually has two hubs closely sandwiched together, so it would be best to cut at the larger area.

Thank you,

Jamie

User avatar
Shannon
Posts: 13224
Joined: Fri Nov 25, 2011 11:58 pm
Location: Canada
Contact:

Re: Fernco to Caste iron bell?

Post by Shannon » Sat Jul 19, 2014 12:24 pm

There maybe some that do i'm afraid I could not say with certainty one way or the other.
If you've found our videos or website information helpful, please considering making a donation using PayPal or pledging us on Patreon

Post Reply