Replacing outdoor valve

Discuss plumbing related issues here - pex, drains, etc.
Post Reply
HuCdReeRYD
Posts: 1
Joined: Mon Aug 05, 2019 2:22 am

Replacing outdoor valve

Post by HuCdReeRYD » Mon Aug 05, 2019 2:45 am

I have this outdoor valve to the sprinklers, but it doesn't shut off completely (however tight I turn it, some water is still running to the sprinklers). I think the valve is old and should be replaced (if you think there's some trick I should try first before replacing, please let me know).

My questions:
1) Should I use a plastic ball valve to replace? Something like this https://www.homedepot.com/p/Homewerks-W ... /202370032 ? Any concern of using such valve for outdoor? (E.g., is a plastic valve more easily damaged than a metal one? Esp. with the sun and outdoor temperature?)

2) How do I replace the valve? In the picture, I can cut the white PVC pipe below the valve, use wrench to twist off the old valve, and put on the new valve. However, how do I join the PVC pipe to the new valve? What fitting should I use?

Thanks in advance!
Attachments
IMG-0987.JPG
Shut-off valve
IMG-0987.JPG (247.55 KiB) Viewed 97 times

User avatar
Aaron
Posts: 3339
Joined: Sat Jan 03, 2015 4:03 pm
Location: St. Paul, MN

Re: Replacing outdoor valve

Post by Aaron » Mon Aug 05, 2019 5:22 pm

I would avoid PVC for sure not least because of deterioration from UV exposure, but also because it's less strong for freeze/thaw of winter. This is not so much a concern if you're in a warm/dry climate. Underground is generally fine as it's protected form UV, but it should be Schedule 80 for rigidity strength.

You could probably repair your valve--I am guessing it's a multi-turn plunger style. If you turn off the water supply do it, the first thing is to remove the center screw or nut to the handle, and pull off the handle. Then use an adjustable wrench to loosen the collar nut to remove the twist valve assembly (you may need to yank it out with pliers). There is a washer on the bottom that is likely deteriorated. You can replace this washer, reassemble the valve, and it should work fine. Could be a very cheap, easy, and fast repair.

Otherwise if you want to replace it, use a quarter-turn full-port ball valve. These are more reliable and generally last indefinitely. The full-port maintains pipe-diameter water flow, so you may even see a slight increase in flow pressure versus the plunger valve.

User avatar
Shannon
Posts: 12869
Joined: Fri Nov 25, 2011 11:58 pm
Location: Canada
Contact:

Re: Replacing outdoor valve

Post by Shannon » Mon Aug 05, 2019 11:21 pm

Yes I agree with Aaron, pull out the guts and take them with you to the plumbing shop for comparison to be sure you get the same thing. I have even just bought entire new valve and swapped the guts to the old valve body when removing the valve body is a no go or finding the right washers is futile.
If you've found our videos or website information helpful, please considering making a donation using PayPal or pledging us on Patreon

Post Reply