Cutting an Opening in LP Smartside Lap Siding

Ask your questions regarding the exterior of your house - siding, roofing, etc.
Post Reply
TacomaCZMan
Posts: 24
Joined: Sun Apr 16, 2017 1:16 pm

Cutting an Opening in LP Smartside Lap Siding

Post by TacomaCZMan » Wed Dec 05, 2018 6:37 am

Planning to install a window in my shed that was built last year. I will be cutting a 24" x 24" rough opening with my circular saw and jig saw. Then I want to remove ~ 4" of the lap siding so I can trim out the new window with the same trim used on the shed building.

I need a different tool to cut in the corners so as to not go ½" past and create something that want look good. Maybe a multitool???
9QsOu1t4QcuKYFqrGVI5bw.jpg
New Shed
9QsOu1t4QcuKYFqrGVI5bw.jpg (240.74 KiB) Viewed 86 times


User avatar
Shannon
Posts: 11381
Joined: Fri Nov 25, 2011 11:58 pm
Location: Canada
Contact:

Re: Cutting an Opening in LP Smartside Lap Siding

Post by Shannon » Wed Dec 05, 2018 7:11 am

Yes a multi tool or oscillating saw would be a good choice. If you want to use something you already own or something that is less expensive to purchase then a nice sharp chisel will also do the trick to finish the corners.
If you've found our videos or website information helpful, please considering pledging us on Patreon

TacomaCZMan
Posts: 24
Joined: Sun Apr 16, 2017 1:16 pm

Re: Cutting an Opening in LP Smartside Lap Siding

Post by TacomaCZMan » Sat Dec 08, 2018 9:17 am

I didn't think of the short chisel. Was looking at the Makita TM3010CX1. I do have a stud to cut out on the back side. Appreciate the reply Shannon. Will post a pick of the backside for another question.

Post Reply